Table of Contents
Advertisement
OPERATING yOUR BREvILLE PROdUCT
BEFORE FIRST USE
Machine Preparation
Remove and discard all labelling and
packaging materials attached to your
espresso machine. Ensure you have removed
all parts and accessories before discarding
the packaging. Clean parts and accessories
(water tank, portafilter, filter baskets and
jug) using warm water and a gentle dish
washing liquid and rinse well. Wipe the
outer housing and drip tray with a soft damp
cloth and dry thoroughly. Do not immerse
the outer housing, power cord or power plug
in water or any other liquid.
The water filter located inside the water tank
will need to be removed before washing the
water tank
Conditioning the Water Filter
•
Remove filter from the plastic bag and
soak in a cup of water for 5 minutes.
•
Rinse filter under cold running water.
•
Wash the stainless steel mesh in
the plastic filter compartment with
cold water. Insert the filter into the
filter holder.
•
Set the dial date 2 months ahead.
•
To install filter, push down to lock
into place.
•
Slide the water tank into position and
lock into place.
NOTE
Do not clean any of the parts or
accessories in the dishwasher.
BES810BSS_ANZ_IB_E14.indd 13
FIRST USE
Initial Start Up
•
Fill tank with water
•
Press POWER button
•
A pumping sound will be heard.
The machine will reach operating
temperature and go into 'Standby' mode.
Flushing the Machine
It is recommended to complete a water
flushing operation, without ground coffee, to
ensure the machine has been conditioned.
When the machine has reached 'Standby'
mode, run the following 2 steps.
•
Turn the Control Dial to the 'Espresso'
position for 30 seconds.
•
Turn the Control Dial to the 'Steam'
position to activate steam for
10 seconds.
•
Repeat this cycle several times.
NOTE
To purchase water filters contact
Breville Customer Service Centre
on 1300 139 798 (Australia) or
0800 273 845 (New Zealand).
13
27/06/2014 5:26 pm
Hide quick links:
Advertisement
Table of Contents
