Performing The Ip Configuration; Preparing The Definitive Connection - THOMSON ViBE VS7000 User Manual

Performing the IP Configuration

Preparing the Definitive Connection

ViBE VS7000
User Manual
Chapter 2 'Installation and Startup' — Performing the Initial Settings
1. Select the System
2. Go to the IP category.
3. Set the Control (X6 on 6RU and 10RU devices) network on your
control/command network:
If there are n nodes in the system, you need n consecutive
addresses, plus one for supervision.
Set the following parameters:
- Address
- Mask
- Gateway (optional)
- First address: first address of the n consecutive addresses
- Supervision address
4. Set the Data 1 (X2 on 6RU and 10RU devices) network on your data
network:
If there are n nodes in the system, you need n consecutive
addresses.
Set the following parameters:
- Address
- Mask
- Gateway (optional)
- First address: first address of the n consecutive addresses
5. Click Apply.
Once you have made your IP configuration from the GUI:
1.
Disconnect the supervision PC from the GigE switch.
tab.
31