Cw Mode Operation; Setup For Straight Key; And Straight Key Emulation ) Operation - Yaesu FT-410 Operation Manual

cW M
Ode
The powerful CW operating capabilities of the FT-410 include operation using both an electronic keyer
paddle and a "straight key" or emulation thereof, as is provided by a computer-based keying device.
S S
etup for trAiGht
Before starting, connect your key to the front panel KEY jack in the status that turned off the [ Power / LOCK ]
switch, and be sure the [ KEYER ] button is turned off for now.
1. Press the [  ] / [  ] buttons to select the operating
band.
By pressing the [  ] / [  ] buttons, the operating band
will change as follows.
7  10  14  15  18  21  24.5  28  1.8
 3.5  7 ......
2. Press the [ MODE] buttons to select the CW mode.
3. R o t a t e t h e [ M A I N D I A L ] k n o b t o a d j u s t t h e
operating frequency.
If you use the MH-31
operating frequency by the [ UP ] / [ DWN ] buttons on
the microphone.
4. Press the [ VOX] button to engage automatic
activation of the transmitter when you close the CW
key. The "BK" icon will appear in the display.
5. When you close your CW key, the transmitter will
automatically be activated, and the CW carrier
will be transmitted. When your release the key,
transmission will cease after a brief delay.
n :
OTe
Do not use the plug except the 3.5-mm 3-pin type plug. If the plug in correct size is not used the radio
may be harmed or damaged.
Page 22
O
peraTiOn
(
K S
ey ANd trAiGht
, you may adjust the
B8
) o
K
ey emulAtioN
[▼]/[▲] button
M-012
14.195.000
button [MAIN DIAL]
[KEYER]
button
[MENU]
FT-410 O
peraTiOn
perAtioN
button
[VOX]
knob
button
[MODE]
M
anual