Yaesu FT-410 Operation Manual page 29

Receiver
Circuit Type:
Intermediate Frequencies:
Sensitivity (IPO "OFF", ATT: OFF):
Squelch Sensitivity:
(IPO "OFF", ATT: "OFF")
Selectivity (–6/–60 dB):
Image Rejection:
IF Rejection:
Maximum Audio Output:
Audio Output Impedance:
Specifications are subject to change, in the interest of technical improvement, without notice or obligation,
and are guaranteed only within the amateur bands.
FT-410 O
peraTiOn
Double-conversion superheterodyne
67.899 MHz / 24 kHz
SSB/CW (2.4 kHz, 10 dB S+N/N)
AM (6 kHz, 10 dB S+N/N, 30 % modulation @400 Hz)
There is no specification in frequency ranges not listed.
SSB/CW/AM
There is no specification in frequency ranges not listed.
Mode
SSB/CW (W)
CW (N)
AM
80 dB or better
80 dB or better
10 W into 4 Ohms with 5% THD (EXT Speaker)
4 to 16 Ohms (8 Ohms: nominal)
M
anual
s
peciFicaTiOns
0.25 µV (0.5 - 1.8 MHz)
0.25 µV (3.5 - 30 MHz)
0.20 µV (50 - 54 MHz)
2.00 µV (1.8 - 2.0 MHz)
2.00 µV (3.5 - 30 MHz)
1.00 µV (50 - 54 MHz)
2.50 µV (1.8 - 30 MHz)
1.00 µV (50 - 54 MHz)
– 6 dB
2.0 kHz or better
300 Hz or better
6 kHz or better
– 60 dB
4.5 kHz or less
1.2 kHz or less
20 kHz or less
Page 29