Table of Contents
Advertisement
3100 Wood Stove Series (ACC)
7
Appliance Set Up
A. Pedestal Assembly and Ash Removal
System (ARS) Installation for Step Top
Uni-body
NOTE: The Ash Removal System, must be
installed fi rst before installing the pedestal.
Included in Kit: Door assembly, door handle & magnet,
ash drawer, fastener package. A cover plate that is required
for a fl oor outside air installation on a pedestal model is also
included, If not needed, discard.
Tools Required: Phillips head screwdriver, 7/16 socket
wrench, 3/32 and 5/36 Allen wrench.
Begin installing the ARS System.
1. Remove 2 front bricks as shown in Figure 22.1.
2. Lay body of stove on its back on a protective pad or pallet.
3. Remove the 2 nuts and 2 bolts holding the channel in
place and set the channel aside. Discard the 2 nuts.
Install the gasket over the 8 protruding screws.
The glossy side of the gasket needs to go against the fi rebox
bottom.
It is important the gasket is not put on upside
down as it could compromise its sealing capa-
bilities.
Figure 22.2.
4. Install ash door assembly by sliding the rod at an angle
into the slot on the left side. As the rod starts passing
through the slot, slide the handle over the rod and then
fi nish pushing the rod through the slot.
Slide the ash door over the 8 screws protruding from the
bottom of the stove. Secure with nuts and washers pro-
vided. Figure 22.2.
5. Re-install handle using a 3/32 Allen wrench to tighten the
set screw in the door handle. The set screw needs to be
snug. Figure 22.3.
6. Install magnet using a Phillips head screw driver. This
magnet will hold the door handle in an open position
which in turn holds the ash door open so ashes can be
brushed into the ash drawer. Figure 22.2.
Do NOT operate before fully assembling components.
Burning your stove without a pedestal or leg kit
attached:
•
Will void your warranty.
•
May result in property damage or personal injury.
Page 22
WARNING
Remove 2 bricks for
installation and then re-install
Figure 22.1
Door Handle
Magnet
Start sliding rod at
an angle into slot,
slide handle over rod
and then finish
pushing through slot.
Figure 22.2
Set Screw
(align with flat
side of rod)
Door handle must be
in open position to
tighten set screw
Figure 22.3
7033-277N
ARS Cover
2
2
Glossy side of
Gasket
against firebox
bottom
Lay stove flat on
protective padding or
pallet
Ash Door
Assembly
Ash Door Rod shown
in installed position
August 3, 2015
R
Advertisement
Table of Contents
