Cadillac SRX 2012 Owner's Manual page 400

Hide thumbs Also See for SRX 2012:
Table of Contents

Advertisement

10-60
Vehicle Care
The TPMS can warn about
a low tire pressure condition but
it does not replace normal tire
maintenance. See Tire Inspection
on page 10 62, Tire Rotation on
page 10 63 and Tires on
page 10 49.
Notice: Tire sealant materials are
not all the same. A non-approved
tire sealant could damage
the TPMS sensors. TPMS
sensor damage caused by
using an incorrect tire sealant
is not covered by the vehicle
warranty. Always use only
the GM-approved tire sealant
available through your dealer
or included in the vehicle.
Factory-installed Tire Inflator Kits
use a GM approved liquid tire
sealant. Using non-approved tire
sealants could damage the TPMS
sensors. See Tire Sealant and
Compressor Kit on page 10 73 for
information regarding the inflator
kit materials and instructions.
TPMS Malfunction Light and
Message
The TPMS will not function properly
if one or more of the TPMS sensors
are missing or inoperable. When
the system detects a malfunction,
the low tire pressure warning light
flashes for about one minute and
then stays on for the remainder
of the ignition cycle. A DIC
warning message also displays.
The malfunction light and DIC
warning message come on at each
ignition cycle until the problem is
corrected. Some of the conditions
that can cause these to come
on are:
One of the road tires has been
.
replaced with the spare tire.
The spare tire does not have a
TPMS sensor. The malfunction
light and the DIC message
should go off after the road
tire is replaced and the sensor
matching process is performed
successfully. See "TPMS Sensor
Matching Process" later in this
section.
I n f o r ma t i o n P r o v i d e d b y :
The TPMS sensor matching
.
process was not done or
not completed successfully
after rotating the tires.
The malfunction light and
the DIC message should go
off after successfully completing
the sensor matching process.
See "TPMS Sensor Matching
Process" later in this section.
One or more TPMS sensors
.
are missing or damaged.
The malfunction light and
the DIC message should go
off when the TPMS sensors
are installed and the sensor
matching process is performed
successfully. See your dealer
for service.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents