Cadillac SRX 2012 Owner's Manual page 315

+ RES (Resume/Accelerate):
Press briefly to make the vehicle
resume to a previously set speed
or press and hold to accelerate.
SET (Set/Coast): Press to set the
speed and activate cruise control or
make the vehicle decelerate.
J
OFF (Cancel): Press to
disengage cruise control without
erasing the set speed from memory.
Setting Cruise Control
If the cruise button is on when not in
use, it could get bumped and go into
cruise when not desired. Keep the
cruise control switch off when cruise
is not being used.
The cruise control light on the
instrument panel cluster comes on
after the cruise control has been set
to the desired speed.
J
1. Press .
2. Get up to the desired speed.
3. Press and release the SET
button located on the steering
wheel.
4. Take your foot off the
accelerator.
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
are applied, the cruise control is
disengaged without erasing the
set speed from memory.
Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
press the +RES button on the
steering wheel. The vehicle returns
to the previous set speed and stays
there.
I n f o r ma t i o n P r o v i d e d b y :
Driving and Operating
Increasing Speed While Cruise
Control is at a Set Speed
If the cruise control system is
already activated,
Press and hold the +RES button
.
on the steering wheel until the
desired speed is reached, then
release it.
To increase vehicle speed in
.
small amounts, press the +RES
button. Each time this is done,
the vehicle goes about 1.6 km/h
(1 mph) faster.
Reducing Speed While Cruise
Control is at a Set Speed
If the cruise control system is
already activated,
Press and hold the SET button
.
on the steering wheel until the
desired lower speed is reached,
then release it.
9-37