Turn Signal Lamps - Cadillac SRX 2012 Owner's Manual

Front Turn Signal Lamp
(Base and Uplevel)
To replace the Front Turn
Signal Lamp:
1. Remove the turn signal lamp
bulb socket from the headlamp
assembly.
2. Remove the turn signal lamp
bulb from the socket.
3. Replace the bulb in the bulb
socket.
4. Install the bulb socket in the
headlamp assembly.
5. For driver side, reinstall the
underhood electrical center
cover by latching three clips.
6. For passenger side, reinstall the
air filter/cleaner assembly base
by pushing to seat . Verify the
base is seated securely, then
install the engine air filter/
cleaner assembly.

Turn Signal Lamps

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2 14.
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release
the taillamp cover (B).
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten from snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
10-37