Temperature Setting - Smith HSE-VAS-015 User Manual

Temperature Setting

Switch on the water heater's power supply.
The green indicator light glows.
Temperature setting
Turn the thermostat knob clockwise for the
device to commence heating and change the
set temperature. A red light will glow. [The
set temperature increases if the thermostat
knob is turned clockwise.] Temperature can
be set in the range of 25°C to 75°C.
Recommended to keep thermostat knob
notch position always in medium or above
level.
Heating mode
When the actual temperature of the water
is less than the set temperature, it enters
into Heating mode. The Heating indicator
glows as shown in (Fig. 18)
Figure 18
When the temperature of the water drops by 5°C from the set temperature due to usage of
water, the water heater again enters into heating mode.
Figure 17
Power
indicator
Standby mode
After the water heater reaches set temperature,
it will enter into the Standby mode due to the
cut-off power and the Power indicator will glow
and Heating indicator switches off as shown in
(Fig. 19)
Figure 19
13
Heating
indicator