Mounting the Water Heater
•
Before locating the position for
installation of the water heater, make sure
that there is sufficient clearance between
the ceiling and the side wall
•
Select a place to mount water heater
vertically, with water connection at the
bottom.
Figure 6
•
Use a drill bit with diameter of 10mm to
drill 2 holes at least 90mm deep in the
wall (Fig. 8 : Step 3). The two holes
should be aligned horizontally. The
horizontal distance between the 2 holes
should be 150mm. (Fig. 8 : Step 2)
Figure 8
1
2
Drilling
Tool
3
90 mm
Concrete
Hole
Wall
7
•
Water heater must be located within
3-1/2 ft. (approx.) from a grounded
230V electrical outlet.
•
Make sure that the wall can withstand
at least twice the weight of the water
heater when completely filled with
water.
Figure 7
Solid
Concrete
Wall
•
Insert the Expansion Anchors into the
holes (Fig. 9 : Step 1).
•
Place the Hanging screws over the
expansion anchors and tighten the
Hanging Screws by rotating it till it gets
fixed steadily (Fig. 9 : Step 2).
Figure 9
1
Concrete
Wall
2
Concrete
Wall
3-1/2 ft.
False
Wall
Expansion
Anchors
Hole
Hanging
Screws