Table of Contents
Advertisement
Auto channel function
The auto channel function automatically checks for calling sig-
nals or ringer signals on all or select channels.
If you hear ringer tone, specified in set mode, you can answer
the call by simply pushing the [PTT] switch. It is not neces-
sary to select a channel first.
q Push [
f
(AUTO CH)] to turn the auto channel function ON.
• "A" appears and scan starts.
"A" appears while the auto
channel function is in use.
w When receiving a ringer tone, push [PTT] to answer.
e To call a waiting station, push [
tone.
• To call a waiting station by voice, push [PTT] until beep tones
sound (for longer than the ringer time), then speak into the mi-
crophone.
r When the auto reset timer is turned OFF, push [
CH)] to restart the auto channel function.
t Push [
f
(AUTO CH)] to cancel the function.
Auto reset time is the period before the auto channel function
restarts after a busy signal disappears and in which no oper-
ation is performed while the auto channel function is in use.
5 to 60 sec. in 5 sec. steps or OFF can be programmed.
q While pushing [Y] + [?], turn power ON to enter set mode.
w Push [?] several times until "AR" appears.
e Push [Y] or [Z] to select the auto reset time or to turn the
r Turn power OFF to exit set mode.
] to transmit a ringer
f
(AUTO
RINGER FUNCTION
Auto reset timer
• Set mode is not available depending on dealer setting.
function OFF.
5 sec. auto reset time
Auto reset timer is cancelled.
5
[
11
Advertisement
Table of Contents
