Change Your Access Point Ip Address; Configure Your Internet Connection - TRENDnet TEW-817DTR User Manual

TRENDnet User's Guide

Change your access point IP address

Setup > LAN Settings
Typically, the access point IP address settings only needs to be changed when
connecting the access point to your network and configuring to the device to be in the
same IP network as your existing network.
Default Access Point IP Address Settings: 192.168.10.1 / 255.255.255.0
1. Log into the management page (see
2. Click on Main, and click on Network Settings.
3. Under Connection Type, click the drop-down list to select the access point IP address
settings.
 IP Address: Enter the new access point IP address. (e.g. 192.168.0.100)
 Subnet Mask: Enter the new access point subnet mask. (e.g. 255.255.255.0)
4. To save changes, click Apply.
Note: You will need to access your access point management page using your new
access point IP address. (e.g. Instead of using the default
new access point IP address will use the following format using your new IP address
http://(new.ipaddress.here) to access your access point management page. You can
also use the default login URL http://tew-817dtr
Your access point can be used as a DHCP (Dynamic Host Configuration Protocol) server
to automatically assign an IP address to each wireless device connected. The DHCP
server settings can be accessed when access point is set to Static IP address and it is
disabled by default
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access your management page" on page 7).
http://192.168.10.100
 Enable DHCP Server: Select to enable DHCP server.
 DHCP Start IP: Enter the starting DHCP IP address to assign.
 DHCP End IP: Enter the ending DHCP IP address to assign.
 Primary/Secondary DNS: Assign DNS IP address to use
 DHCP Lease Time: Select the DHCP lease time allowed.

Configure your Internet connection

Advanced > Setup > Internet Settings
In repeater mode the access point will just repeat the wireless signal of an existing
network. Setting up the Internet connection will allow you to manually enter an
assigned IP address for the connected network. Typically this setting is not required to
be completed.
your
1. Log into the management page (see
2. Click on Advanced and click on Setup, then click on Internet Settings.
3. Under Connection Type in drop-down list, select the type of connection type the
device is connected to.
 DHCP: Select to this option to have the device automatically obtain DHCP IP
address from the connected network.
TEW-817DTR
"Access your management page" on page 7).
61