TRENDnet User's Guide
1. Log into the management page (see
2. Click on Basic, and click on Wireless.
3. Under Security, click on the Security Mode drop-down list to select your wireless
security type.
Selecting WEP:
If selecting WEP (Wired Equivalent Privacy), please review the WEP settings to configure
and click Apply to save the changes.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access your management
page" on page 7).
Security Mode: Choose WEP-OPEN, WEP-SHARED, or WEP-AUTO.
Note: It is recommended to use Open since it is known to be more secure than
Shared Key.
Default Key: Choose the key index to use for security to the corresponding WEP
Keys 1-4. You can only use one key at any given time.
Note: Please note that they wireless client key index 1-4 should also match the key
index chosen here in order to establish connection.
WEP Key 1-4: Enter the WEP key. This is the password or key that is used to
connect your computer to this router wirelessly. You can enter 64-bit or 128-bit
key. You can enter up to four keys but only the one chosen as the Default Key will
be used.
Note: It is recommended to use 128-bit because it is more secure to use a key that
consists of more characters.
Hex/ASCII: Enter the WEP key format. See the table below for the acceptable
characters and lengths for each format.
WEP Key Format
HEX
Character set
0-9 & A-F, a-f only
64-bit key length
10 characters
128-bit key length
26 characters
Selecting WPA-Personal / WPA2-Personal / WPA2-Personal Mixed
(WPA2-Personal recommended):
TEW-817DTR
ASCII
Alphanumeric (a,b,C,?,*, /,1,2, etc.)
5 characters
13 characters
59