Clone A Mac Address - TRENDnet TEW-817DTR User Manual

TRENDnet User's Guide
enhancements compared to the most commonly used and well known IPv4 (Internet
Protocol Version 4) such as:
 Integrated IPsec – Better Security
 Integrated Quality of Service (QoS) – Lower latency for real-time applications
 Higher Efficiency of Routing – Less transmission overhead and smaller routing tables
 Easier configuration of addressing
Note: In order to use IPv6 Internet connection settings, it is required that your ISP
provide you with the IPv6 service. Please contact your ISP for availability and more
information about the IPv6 service.
1. Log into the management page (see
2. Click on Advanced and click on Setup, then click on IPv6 Settings.
3. Review the IPv6 Internet Connection settings and enter information settings specified
by your ISP. Click Apply to save changes.
Note: Please contact your ISP for IPv6 service availability.
Select the IPv6 connection type provided by your ISP.
 Static IPv6
 Auto-configuration (SLAAC/DHCPv6)
 PPPoE
 6to4
 Link-Local Only
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access your management page" on page 7).

Clone a MAC address

Advanced > Setup > WAN Settings
On any home network, each network device has a unique MAC (Media Access Control)
address. Some ISPs register the MAC address of the device (usually a router or a
computer) connected directly to the modem. If your computer MAC address is already
registered with your ISP and to prevent the re-provisioning and registration process of a
new MAC address with your ISP, then you can clone the address (assign the registered
MAC address of your previous device to your new router). If you want to use the MAC
address from the previous device (computer or old router that directly connected to the
modem, you should first determine the MAC address of the device or computer and
manually enter it into your router using the clone MAC address feature.
Note: For many ISPs that provide dynamic IP addresses automatically, typically, the
stored MAC address in the modem is reset each time you restart the modem. If you are
installing this router for the first time, turn your modem before connecting the router to
your modem. To clear your modem stored MAC address, typically the procedure is to
disconnect power from the modem for approximately one minute, then reconnect the
power. For more details on this procedure, refer to your modem's User Guide/Manual or
contact your ISP.
1. Log into the management page (see
2. Click on Advanced and click on Setup, then click on WAN Settings.
3. In the MAC Address Clone section, click the MAC Clone drop-down list, and select
Enable. Then click Clone Your PC's MAC Address to copy your computer's MAC address
in the MAC Address field.
Note: You can also check the DHCP Client List for the MAC addresses of the devices on
your network, see page 28 or refer to your computer or device documentation to find the
MAC address.
4. To save changes, click Apply.
TEW-817DTR
"Access your management page" on page 7).
25