Bus-Pip10; Bus-Pip11; Bus-Pips For Migrated Towers; Bus Pip Cnsl01 - IBM i 830 Repair Manual

BUS-PIP10

You will perform BUS-PIP10 on an SPD Migrated Tower. Go to "BUS-PIPs for
Migrated Towers".
This ends the procedure.

BUS-PIP11

You will perform BUS-PIP11 on an SPD Migrated Tower. Go to "BUS-PIPs for
Migrated Towers".
This ends the procedure.

BUS-PIPs for Migrated Towers

The failure is in a migrated tower.
SPD migrated towers are connected with a high-speed link and have bus numbers
0004 through 0017 (hexadecimal) or 4 through 23 (decimal).
Use Hardware Service Manager (HSM), the System Configuration Listing or
visually inspect the SPD migrated I/O tower to determine the feature code of the
tower. Record the tower's feature code number.
You will need the Migrated Expansion Tower Problem Analysis, Repair and Parts to
continue. Go to "BUS PIP Entry Point" in the "Bus Problem Isolation Procedures"
section in the Migrated Expansion Tower Problem Analysis, Repair and Parts. Follow
the instructions to get to the BUS-PIP that you were sent there to perform using
the migrated tower feature code that you recorded.
This ends the procedure.

BUS PIP CNSL01

This procedure will direct you to exchange the I/O processor for the system or
partition console.
1. Does the system have multiple partitions?
Yes No
↓
Go to step 11 on page 288 of this procedure.
2. Is the problem on a secondary partition?
Yes No
↓
Go to step 11 on page 288 of this procedure.
3. Can the customer power off the partition at this time?
Yes No
↓
The IOP controlling the partition's console may be controlling other
critical resources. The partition must be powered off to exchange this
IOP. Perform this procedure when the customer is able to power off
the partition. Work with the customer to get the partition ready to be
powered off. Return to step 4 of this procedure when the partition can
be powered off.
4. Power down the partition from the Primary partition's "Work with partition
status" display.
5. Determine the logical address and the frame ID of the console IOP using the
following steps:
v Select option "Work with System Partitions" in SST/DST.
Chapter 3. Problem Isolation Procedures (PIPs), Failing Items, and Symbolic FRU Isolation
Bus, High-Speed Link (HSL) PIPs
287