Heat & Glo ST-36TR-IPI Owner's Manual page 79

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
12 in.
(305 mm)
6-11/16 in.
(169 mm)
3-15/16 in.
(101 mm)
8 in.
(203 mm)
(229 mm)
2-3/4 in.
(70 mm)
12-1/4 in.
(311 mm)
16 in.
(406 mm)
(For use with IPI and DSI appliances only.)
26 in.
660 mm
DVP-HSM-B
Extended Heat Shield
Figure 16.9 SLP Series Vent Components
8 in.
(203 mm)
SLP-TRAP
Horizontal Termination Cap
3-13/16 in.
(97 mm)
SL-2DVP
Adapter
9 in.
12-1/2 in.
(318 mm)
11-1/2 in.
(292 mm)
PVK-80
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. L • 4/15
Heat
Shield
Term Cap
Max
Effective
Trap1
Length
Trap2
3-15/16 in.
(101 mm)
4 in.
102 mm
5-1/16 in.
(128 mm)
14-7/16 in.
367 mm
DVP-FBHT
SL-2DVP
SLP90
ASSEMBLY
Minimum Maximum
Effective Length Effective Length
3-1/8 in. 4-3/4 in.
79 mm 121 mm
5-1/4 in. 9-1/4 in.
133 mm 235 mm
6-3/8 in.
163 mm
4-5/8 in.
117 mm
8-1/8 in.
206 mm
DVP-2SL
Adapter
14-7/16 in.
367 mm
SLP-WT-BK
Wall Thimble-Black
4-3/16 in.
106 mm
5-1/16 in.
128 mm
2-5/16 in.
59 mm
DVP-FBHT
79