Heat & Glo ST-36TR-IPI Owner's Manual page 66

STEP 4.
LOG #3 (SRV2005-702): Position log #3 as shown by leaning it against log # 2 and resting the other end on the
peak of the burner. DO NOT cover any port holes.
SHARP SHARP
NOTCH NOTCH
STEP 5.
LOG #4 (SRV2005-703): Locate the sharp notch on log #4 against the grate tine as shown. The smooth cutout
on the bottom of log #4 should rest on the burner surface. The side of Log #4 must be 3/4 inch from the nearest port hole
on the right side of log #4. DO NOT cover any port holes.
STEP 6.
LOG #5 (SRV2005-704): Using the sharp notch on the heavy end of log #5, align it on the grate tine and set it
on the fl at area of log #4 as shown.
66
SHARP SHARP
NOTCH NOTCH
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. L • 4/15
2 2
3 3
2 2
4 4
3/4 IN. 3/4 IN.
3 3
3 3 2 2
5 5
2
GRATE GRATE
TINE TINE
1 1
1 1
1
4 4 1 1