Draytek Vigor2760 series User Manual page 279

Dial-Out Settings Type of Server I am calling - PPTP - Build a PPTP VPN
connection to the server through the Internet. You should
set the identity like User Name and Password below for the
authentication of remote server.
IPsec Tunnel - Build an IPsec VPN connection to the
server through Internet.
L2TP with IPsec Policy - Build a L2TP VPN connection
through the Internet. You can select to use L2TP alone or
with IPsec. Select from below:

None: Do not apply the IPsec policy. Accordingly, the
VPN connection employed the L2TP without IPsec
policy can be viewed as one pure L2TP connection.

Nice to Have: Apply the IPsec policy first, if it is
applicable during negotiation. Otherwise, the dial-out
VPN connection becomes one pure L2TP connection.
Must: Specify the IPsec policy to be definitely applied on
the L2TP connection.
User Name - This field is applicable when you select,
PPTP or L2TP with or without IPsec policy above. The
length of the name is limited to 49 characters.
Password - This field is applicable when you select PPTP
or L2TP with or without IPsec policy above. The length of
the password is limited to 15 characters.
PPP Authentication - This field is applicable when you
select, PPTP or L2TP with or without IPsec policy above.
PAP/CHAP is the most common selection due to wild
compatibility.
VJ compression - This field is applicable when you select
PPTP or L2TP with or without IPsec policy above. VJ
Compression is used for TCP/IP protocol header
compression. Normally set to Yes to improve bandwidth
utilization.
IKE Authentication Method - This group of fields is
applicable for IPsec Tunnels and L2TP with IPsec Policy.

Pre-Shared Key - Input 1-63 characters as pre-shared
key.

Digital Signature (X.509) - Select one predefined
Profiles set in the VPN and Remote Access >>IPsec
Peer Identity.
Peer ID - Select one of the predefined Profiles set in
VPN and Remote Access >>IPsec Peer Identity.
Local ID – Specify a local ID (Alternative Subject
Name First or Subject Name First) to be used for
Dial-in setting in the LAN-to-LAN Profile setup. This
item is optional and can be used only in IKE
aggressive mode.

Local Certificate – Select one of the profiles set in
Certificate Management>>Local Certificate.
IPsec Security Method - This group of fields is a must for
IPsec Tunnels and L2TP with IPsec Policy.
267 Vigor2760 Series User's Guide