Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-24NKHD-E4 Service Manual

8-2. Installation Diagram of Indoor and Outdoor Units

5 Sasa-Zeolite plus filter
Before installing the
wireless remote control
• With the remote control cover
open, load the batteries supplied
correctly, observing their
polarity.
2
Wireless remote control
Cover
3
Batteries
18 Class Heat pump
Loop the connecting cable (about 100 mm
in diameter and 300 - 350 mm long).
6 Plasma air purifier
2 Wireless remote control
Extension
drain hose
(Not available,
provided by
installer)
Electric
parts cover
1 Installation
Hook
plate
Hook
Shield
pipe
Vinyl tape
Apply after carrying
out a drainage test.
18 Class Cooling
Loop the connecting cable (about 100 mm
in diameter and 300 - 350 mm long).
− 44 −
FILE NO. SVM-05016
For the rear left and left piping
Insert the cushion between
the indoor unit and wall, and
tilt the indoor unit for better
operation.
Do not allow the drain hose to
get slack.
Cut the piping
hole sloped
slightly .
Make sure to run the drain
hose sloped downward.
The auxiliary piping can be
connected to the left, rear left,
rear, right or bottom.
Right
Rear
Rear left
Bottom
Insulate the refrigerant pipes
separately with insulation, not
together.
6 mm thick heat resisting
polyethylene foam
Saddle
Extension
drain hose
(Not available,
provided by
installer)
Electric
parts cover
24 Class
Wall
Left