Fujitsu AUU7RLF Design & Technical Manual page 134

REMOTE CONTROLLER CUSTOM CODE SETTING
„ „
In function setting, please change to the setting that custom code setting of Wireless remote
controller is the same as indoor unit according to the following content when you change
custom code setting of indoor unit.
1. Press the START/STOP button until only the
clock is displayed on the remote controller
display.
3. Press the SET TEMP. "
to change the custom code between A→B→C
→D.
● If no buttons are pressed within 30 seconds after the custom code is displayed, the system
returns to the original clock display. In this case, start again from step 1.
● The air conditioner custom code is set to A prior to shipment.
● The remote controller resets to custom code A when the batteries in the remote controller are
replaced. If you use a custom code other than custom code A, reset the custom code after
replacing the batteries. If you do not know the air conditioner custom code setting, try each of
the custom codes (A→B→C→D) until you find the code which operates the air conditioner.
" or the " " button
p q
- (01 - 130) -
2. Press the MODE button for at least five
seconds to display the current custom code
(initially set to A).
4. Press the MODE button again to return to
the clock display. The custom code will be
changed.