Vertex Standard EVX-531 Operating Manual page 39

s s
( eVx-534 & eVx-539 )
tatus et
You can change the 5-tone status code using this
function:
r Press, (or press and hold), the assigned PF key to
change the 5-tone status code.
r Enter the 5-tone status code directly from the
keypad ([ 0 ] - [ 9 ] key ) .
r Press the [ D ] key, The display indicates "- SET -"
briefly and store the new number to the 5-tone
status code.
You may cancel the new setting by pressing
the [ C ] key. In this case, the display indicates
"- CANCEL -" briefly.
s u /d
( eVx-534 & eVx-539 )
tatus p oWn
Press, (or press and hold), the assigned PF key to
select a 5-tone status code from the pre-defined status
list.
s c
tatus hecK ( eVx-534 & eVx-539 )
Press, (or press and hold), the assigned PF key to
check the 5-tone receive status code. When you press
this key, the display will indicate the "Message" cor-
responding to the receive status condition per the pre-
defined status list.
EVX-530 S O
EriES pErating
a o
dVanced peratIon
M
anual
d
( eVx-534 & eVx-539 )
uty
Press, (or press and hold), the assigned PF key to
toggle the Duty function of the 2-tone, 5-tone, or
MDC1200 "On" and "Off".
®
When the Duty function is set to "On", the display in-
dicates "DUTY ON" briefly and the user will always
hear (depending on the sub-audio signaling) all traf-
fic on the paging channel. The radio will sound the
paging alert when it receives the programmed 2-tone,
5-tone, or MDC1200 ® .
When the Duty function is set to "Off", the display
indicates "DUTY OFF" briefly and the user will
NOT hear normal radio traffic on the paging chan-
nel. The radio will sound the paging alert and unmute
only when it receives the programmed 2-tone, 5-tone,
or MDC1200 .
®
Id c
hecK ( eVx-534 & eVx-539 )
This function allows logged ID of the DTMF Signal-
ing or 5-tone Signaling to be reviewed and relayed
(5-tone Signaling only) to a specific station:
r Press, (or press and hold), the assigned PF key to
display the logged ID of the DTMF Signaling or
5-tone Signaling.
37