Vertex Standard EVX-531 Operating Manual page 33

( ta )
t a
alK round
Press, (or press and hold), the assigned PF key to
activate the Talk Around feature when you are op-
erating on duplex channel systems (separate receive
and transmit frequencies, utilizing a "repeater" sta-
tion). The Talk Around feature allows you to bypass
the repeater station and talk directly to a station that
is nearby. This feature has no effect when you are
operating on "simplex" channels, where the receive
and transmit frequencies are already the same. In the
EVX-534/-539, when the Talk Around feature is ac-
tivated, the " " icon will be indicated on the display.
Note that your dealer may have mode provision for
"Talk Around" channels by programming "repeater"
and "Talk Around" frequencies on two adjacent chan-
nels. If so, the key may be used for one of the other
Pre-Programmed Functions.
Note: The Talk Around feature does not activate on
the Simplex Channel.
reset
Press (or press and hold) the assigned PF key to reset
the RFC (Ready for Communication) condition.
EVX-530 S O
EriES pErating
a o
dVanced peratIon
M
anual
c 1 c 3
( eVx-531 )
all to all
c 1 c 5
all to all ( eVx-534 & eVx-539 )
Press, (or press and hold), the assigned PF key to
send a pre-programmed call signal of the 2-Tone,
5-Tone, MDC1200 or Digital Call.
®
c u /d
ode p oWn ( eVx-534 & eVx-539 )
Press, (or press and hold), the assigned PF key to
select a 2-Tone or 5-Tone encode code from the pre-
programmed encode list.
c s
ode et ( eVx-534 & eVx-539 )
You can change the desired digit of the 5-Tone en-
code code using this function:
r Press, (or press and hold), the assigned PF key.
r Enter the desired 5-Tone encode code directly
from the keypad ([ 0 ] - [ 9 ] key ) .
r Press the [ D ] key to store the new setting. The
display indicates "- SET -" briefly, then reverts to
the normal channel indication.
You may cancel the new setting by pressing
the [ C ] key. In this case, the display indicates
"- CANCEL -" briefly.
31