Table of Contents
Advertisement
3. Adjust air shutters on individual burners for proper
AIR SHUTTER
ADJUSTMENT
flame appearance.
(See illustration "C")
4. Adjust low flame setting at each burner by turning
This appliance is shipped from the factory with air
adjustment screw in center of valve stem.
shutters adjusted for use with natural gas. If further
adjustment is necessary, or to reset for use with LP,
To make these conversion adjustments follow the
adjust air shuttersas follows:
instructions and illustrations ("A" through "D").
Grill Burnerand Surface BurnerCartridge Air Shutters
(see illustration "C").
$ The left hand air shuttercontrolsthe rear half of the
bumer.
S The right handshutter controlsthe fronthalf.
S Accessto air shutters on the surface burner cartridge
may be found throughopeningson the bottom of the
cartridgehousing.
Slideair shutterbackwardor forwardto increase or
decrease the size of the air opening.Air shutters fit
snugly,so a screwdriverblade may be requiredto make
this adjustment(see illustration.)
Observe change in flame appearance as the air shutter is
This appliance is shippedfrom the factory with orifice
moved.Adjustmentis satisfactorywhen a cleady defined,
hoodsdrilledfor use with natural gas. To convert from
even blue flame resultsat the high flame setting. The
naturalgas to LP, applya 1/2" open-endedwrench to hex
snugfit of the air shutter assures it willremain positioned
sectionof orifice hood.TURN COUNTERCLOCKWISE
correctly.
TO REMOVE. Save the NaturalGas orificehoodsjust
removedfrom this appliancefor future use. Installcolor
coded orifice hoods supplied.(SEE GAS CONVERSION
INSTRUCTIONS PAGE 14,) TURN CLOCKWISE TO
INSTALL. Hold dimensionspec'fiad n "llustrat'on "B".
CONTROL SETTINGS
The size and type of cookwareand the amount and type
GRILL B URNER AIRSHU'Fi'ER & SURFACE B URNER
of foodbeing cookedwillinfluencethe setting neededfor
_(IF
SOEQUIPPED)
best cooking results.The setting indicated should serve
_'__,
___
as a guide while you become familiar with your cooktop.
_OQ
Use the Hi flame setting to
_
--
_
'_o_
qu,ck,y
bring
foods
to abo,, or t o
begin a cookingoperation.Then
AIR SHU'I-rER_
/
v
reduce to a lowersettingto
,
'-- INSERT S CREWDRIVER
continuecooking.Never leave
BLADE INSLOT AND
food unattended over a Hi flame
TWIST WITH SLIGHT
PRESSURE TO
setting.
ALLOW AIR SHUTrER
TO SLIDE EASILY.
Med setting is used to continue a
cooking operation. Food will not
_
AIR SHUTTER
cook any faster when a Hi flame
,..---a
setting
is used than that needed
_
_/_
to maintain a gentle boil.
Remember, water bolls at the
same temperature whether
boilinggently or vigorously.
Use Lo setting to keep food at
F"-_
serving temperatures without
further cooking. You may find
that some cooking may take
_-_-_
place if the cookware is covered,
-12-
Advertisement
Table of Contents
