Remove the hard drive from the system unit.
7.
Note
If the pull tab is broken off and you are unable to remove the hard drive, see "Hard
Drive Bay and Drive Removal" later in this section.
SO-DIMM Module Removal
Remove the SO-DIMM module(s) as follows.
Close all applications, shut down the operating system, turn off system power, and unplug
1.
the AC power adapter and power cord from the power source and the back of the system
unit.
Turn off and disconnect all peripherals.
2.
Carefully position the system with the LCD panel swiveled to the right, as shown in the
3.
following figure.
3-4 Disassembly and Reassembly
Removing the Hard Drive
A – Interface Cable
B – Pull Tab
C – Hard Drive