Dimm Module Removal; Diskette Drive Removal - NEC POWERMATE PROFESSIONAL 9000 Service Manual

4. Remove the four screws, two to a side, securing the diskette drive in the slot (see
the following figure).
5. Slide the diskette drive out of the slot.

DIMM Module Removal

Remove a DIMM module from the system board as follows.
Turn off the system and disconnect the system power cord from the power
1.
source.
As viewed from the front of the chassis, remove the left side cover on the system
2.
unit (see "System Unit Covers" in Section 3).
3. Remove the drive cage (see "Removing the Drive Cage").
4. Press the plastic clips at the outer edges of the socket away from the memory
module (see the following figure). This ejects the DIMM out of the socket.
NOTE: When reinstalling the drive, note that all
power cables are keyed to fit only in the correct
position.
Figure 5-9 Diskette Drive Removal
Repair 5-9