Dimm Removal And Installation; Removing A Dimm - NEC POWERMATE ES 5200 Service Manual

4. Press down on the latch securing the drive bracket to the chassis and pull the
bracket out of the chassis (see the figure in the previous section). Pull the
bracket out only far enough to access the drive mounting screws and cable
connectors.
5. If a currently installed hard drive is being replaced, see "Removing a 3 1/2-
Inch Hard Drive — Minitower."
6. Insert the new hard drive in the bracket, with the connectors on the drive
facing the interior of the chassis (see the figure in the previous section).
7. Secure the hard drive in the drive bracket with the four screws from the old
device or the screws that come with the new device.
8. Connect the IDE drive signal and power cables to the hard drive.
9. Align the drive bracket with its bay in the chassis and slide the bracket into
the chassis until it clicks in place.
10. Replace the top cover (see "Replacing the Minitower Top Cover").
11. Replace the left side cover (see "Replacing the Minitower Side Covers").
12. Run the Setup program to set the new configuration (see "CMOS Setup
Utility" in Section 2).

DIMM Removal and Installation

Remove or install a DIMM using the following procedures.

Removing a DIMM

If your memory configuration requires the removal of a memory module, use
the following steps.
Before opening the computer or handling boards or memory
modules, reduce static discharge by touching the system's
metal chassis.
1. Remove the system board to access DIMM sockets.
T
For a small desktop system, see "Removing the System Board — Small
Desktop."
T
For a desktop system, see "Removing the System Board — Desktop."
T
For a minitower system, see "Removing the System Board —
Minitower."
2. Locate the system memory upgrade sockets on the system board (see the
figure "System Board Internal Connector Locations"). Either socket (or
both) can contain a memory module.
3-36 Disassembly and Reassembly
! CAUTION