Lexus CT200h Operating Manual page 518

518
7-3. Do-it-yourself maintenance
LED lights
■
The headlight low beams (LED type), parking lights, front side marker lights, daytime
running lights, LED fog lights (if equipped), side turn signal lights, rear side marker lights,
stop/tail lights, high mounted stoplight and license plate lights consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to your Lexus dealer to have the light
replaced.
Condensation build-up on the inside of the lens
■
Temporary condensation build-up on the inside of the headlight lens does not indicate a
malfunction. Contact your Lexus dealer for more information in the following situations:
Large drops of water have built up on the inside of the lens.
●
Water has built up inside the headlight.
●
When replacing light bulbs
■
P. 506
WARNING
Replacing light bulbs
■
Be sure to stop the hybrid system and turn off the lights. Do not attempt to replace the
●
bulb immediately after turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. When it is unavoid-
●
able to hold the glass portion, use and hold with a clean dry cloth to avoid getting
moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so may result
●
in heat damage, fire, or water entering the headlight unit. This may damage the head-
lights or cause condensation to build up on the lens.
Do not attempt to repair or disassemble light bulbs, connectors, electric circuits or
●
component parts.
Doing so may result in death or serious injury due to electric shock.
To prevent damage or fire
■
Make sure bulbs are fully seated and locked.
●
Check the wattage of the bulb before installing to prevent heat damage.
●
CT200h_OM_OM76174U_(U)
I n f o r ma t i o n P r o v i d e d b y :