Lexus CT200h Operating Manual page 188

188
4-5. Using the driving support systems
Cruise control can be set when
■
The shift position is in D.
●
Vehicle speed is above approximately 25 mph (40 km/h).
●
Accelerating after setting the vehicle speed
■
The vehicle can be accelerated normally. After acceleration, the set speed resumes.
●
Even without canceling the cruise control, the set speed can be increased by first accel-
●
erating the vehicle to the desired speed and then pushing the lever down to set the new
speed.
Automatic cruise control cancelation
■
Cruise control will stop maintaining the vehicle speed in any of the following situations.
Actual vehicle speed falls more than approximately 10 mph (16 km/h) below the preset
●
vehicle speed.
At this time, the memorized set speed is not retained.
Actual vehicle speed is below approximately 25 mph (40km/h).
●
Enhanced VSC is activated.
●
If the warning message for the cruise control is shown on the multi-information display
■
Press the "ON-OFF" button once to deactivate the system, and then press the button
again to reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels immediately after
being activated, there may be a malfunction in the cruise control system. Have the vehi-
cle inspected by your Lexus dealer.
WARNING
To avoid operating the cruise control by mistake
■
Switch the cruise control off using the "ON-OFF" button when not in use.
Situations unsuitable for cruise control
■
Do not use cruise control in any of the following situations.
Doing so may result in loss of control and could cause an accident resulting in death or
serious injury.
In heavy traffic
●
On roads with sharp bends
●
On winding roads
●
On slippery roads, such as those covered with rain, ice or snow
●
On steep hills
●
Vehicle speed may exceed the set speed when driving down a steep hill.
During emergency towing
●
CT200h_OM_OM76174U_(U)
I n f o r ma t i o n P r o v i d e d b y :