Lexus CT200h Operating Manual page 228

228
4-5. Using the driving support systems
Likely cause
 The image is blurry
Dirt or foreign matter (such as water
droplets, snow, mud etc.) is adhering to
the camera.
 The image is out of alignment
The camera or surrounding area has
received a strong impact.
 The guide lines are very far out of alignment
The camera position is out of alignment.
• The vehicle is tilted (there is a heavy
load on the vehicle, tire pressure is low
due to a tire puncture, etc.)
• The vehicle is used on an incline.
 The estimated course lines move even though the steering wheel is straight
There is a malfunction in the signals being
output by the steering sensor.
 Guide lines are not displayed
The back door is open.
 The estimated course lines are not displayed
• Battery power is low.
• The steering sensor has been rein-
stalled.
• There is a malfunction in the signals
being output by the steering sensor.
CT200h_OM_OM76174U_(U)
Solution
Rinse the camera lens with water and
wipe it clean with a soft cloth.
Wash with a mild soap if the dirt is stub-
born.
Have the vehicle inspected by your Lexus
dealer.
Have the vehicle inspected by your Lexus
dealer.
If this happens due to these causes, it
does not indicate a malfunction.
Back up while visually checking the vehi-
cle' s surroundings.
Have the vehicle inspected by your Lexus
dealer.
Close the back door.
If this does not resolve the symptom, have
the vehicle inspected by your Lexus
dealer.
Stop the vehicle, and turn the steering
wheel as far as it will go to the left and
right.
If this does not resolve the symptom, have
the vehicle inspected by your Lexus
dealer.
I n f o r ma t i o n P r o v i d e d b y :