ECS P6BAP-Me User Manual page 29

IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
Each IDE channel supports a master device and a slave device. This
motherboard supports UltraDMA. UltraDMA technology provides faster access to
IDE devices. If you install a device which supports UltraDMA, change the
appropriate item on this list to Auto. You may have to install UltraDMA drivers
supplied with this motherboard in order to use an UltraDMA device.
Init Display First
Use this item to define if your graphics adapter is installed in one of the PCI slots.
Power On Function
KB Power ON Password
Hot Key Power ON
The Power On Function item allows you to power on the system by several
options. If you choose Password, you can use the item KB Power On Password
to install a power on password. If you set it to Hot Key, you can then use the item
Hot Key Power On to choose which hot keys are installed. Alternatively you can
choose to power on the system using the Mouse Left or Mouse Right button.
When Button Only is selected you can only power the system on by using the
power button on the case. Keyboard 98 allows you to use a power button
integrated on a windows 98 log compliant keyboard.
KBC input clock
This item sets the clock speed for the keyboard controller. Leave this item at the
default value of 8 MHz.
Onboard FDC Controller
Use this item to enable or disable the floppy disk controller that is built into this
mainboard.
Onboard Serial Port 1
This item lets you disable the built-in serial port 1, or enable it by assigning an
I/O address and an Interrupt Request Line (IRQ).
Onboard Serial Port 2
This item lets you disable the built-in serial port 2, or enable it by assigning an
I/O address and an Interrupt Request Line (IRQ).
UART Mode Select
This item defines the operation of serial port 2. In the Normal setting, serial port 2
is assigned to the external COM2 connector. If you have installed an optional
infrared port, you must change the setting of this item to one of the Infrared
settings (usually IrDA or FIR). These settings will disable the external COM2
serial port connector and assign the resources to the infrared device.
Default: Auto
Default: Auto
Default: Auto
Default: Auto
Default: PCI Slot
Default: Hot KEY
Default: Enater
Default: Ctrl-F12
Default: 8 MHz
Default: Enabled
Default: 3F8/IRQ4
Default: 2F8/IRQ3
Default: IrDA
51