Yamaha RX-V461 Service Manual page 19

QQ
3 7 63 1515 0
3. SPEAKER SET
The analog switch settings for each sub-menu are as shown in the table below.
LARGE: This mode is used for a speaker with high bass reproduction performance (a large unit).
Full bandwidth signals are output.
SMALL: This mode is used for a speaker with low bass reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and distributed to FRONT L/R.
SWFR: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is distributed to FRONT L/R.
3.FRNT:SML 0dB
3.CENTER NONE
3.LFE/B:FRNT
TE
L 13942296513
3.TONE:MAX
3.TONE:MIN
INPUT: DVD ANALOG
SPEAKER OUT: 1 kHz, SUBWOOFER OUTPUT: 50 Hz
Sub-menu
FRONT : SML 0dB
CENTER : NONE
LFE/B : FRNT
TONE : MAX
TONE : MIN
www
.
http://www.xiaoyu163.com
FRONT : SML 0dB
CENTER : NONE
LFE/B : FRNT
TONE : MAX
TONE : MIN
FRONT: SML 0dB
The FRONT L/R signal, when 90 Hz or lower, is mixed to the channel specified by LFE/BASS.
CENTER: NONE
The CENTER signal is distributed to FRONT L/R.
LFE / BASS: FRONT
The LFE (SUBWOOFER) signal is distributed to FRONT L/R.
TONE: MAX
The signal is output with the tone control [BASS +10 dB, TREBLE + 10 dB].
TONE: MIN
The signal is output with the tone control [BASS -10 dB, TREBLE - 10 dB].
Input level Volume
Both ch, -20 dBm +6.0 dB
Both ch, -20 dBm +6.0 dB
Both ch, -20 dBm +6.0 dB
Both ch, -20 dBm +6.0 dB
Both ch, -20 dBm +6.0 dB
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
SMALL LARGE LARGE
LARGE NONE LARGE
LARGE SMALL SMALL
LARGE LARGE LARGE
LARGE LARGE LARGE
Q Q
3 6 7 1 3 1 5
SPEAKER OUT
FRONT CENTER
+11.5 dBm -∞
+11.5 dBm -∞
+11.5 dBm -∞
+14.5 dBm -∞
+8.5 dBm -∞
co
.
RX-V461/HTR-6040/RX-V461DAB
9 4 2 8
SWFR
SWFR
FRONT
SWFR
SWFR
0 5 8 2 9 9 4 2 8
SUBWOOFER
SURROUND OUTPUT
-∞ -3.5 dBm
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
m
9 9
9 9
19