Troubleshooting - Belkin F1DN104P-3 User Manual

TRoublesHooTInG

SECTIONS
Table of Contents
General
as product powers-up all channel-select leds are turned on and
then off . after that a specific, predefined led combination is
turned on . Product is inoperable .
• The product did not pass self-test procedure. Try to power
cycle product. If problem persists please contact your system
administrator or our technical support.
My computer does not boot when connected to the switch but
works fine when I connect my keyboard, video, and mouse directly
to my computer .
• Make sure that the DP/USB KVM Cable Kit is connected tightly
between the Switch and the computer.
The switch does not turn on .
• Ensure that the AC power cord is securely connected to both the
AC inlet and to the wall outlet.
• Check that the power switch is in the ON position.
Belkin Advanced Secure DisplayPort KVM
®
1 2 3
The switch makes rapid clicking noises and the port leds flash
continuously when turned on .
23
4 5
• If the clicking noises continue, the unit may have been tampered
with or experienced severe impact.
noTe: This Switch is equipped with active anti-tamper triggers. Any
attempt to open the enclosure will activate the anti-tamper triggers
and render the unit inoperable. If the unit's enclosure appears
disrupted or if all the port LEDs flash continuously, please call Belkin
Technical Support at (800) 282-2355.
6 7