Table of Contents
Advertisement
INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2
1. Connect one terminal of 15 foot wire from wall switch to male
connector on high limit harness. Connect remaining wire terminal
to TH terminal on valve. Make sure that wire terminals are in posi-
tions on unit as pictured in Figure 14. If wires are not connected
as shown switch will not work.
2. Route 15 foot wire through hole openings with bushings provided
on either side of fireplace cabinet.
3. Connect one bare wire end to each of terminals of GWMS2 wall
switch.
4. Install wall switch and cover in wall.
IMPORTANT: Do not use any other wire than that provided with
GWMS2 wall switch kit. Do not exceed 15 feet of distance from
valve connection. Using wire of higher gauge or turns or exceeding
minimum distance will increase resistance at control valve causing
unreliable performance of fireplace controls.
Remote Receiver
or Wall Switch to
Terminal Marked "TH"
Figure 14 - Connecting Remote Receiver or Wall Switch to the
Gas Control Valve
126741-01C
INSTALLING OPTIONAL CONTROLS
Wire Harness From
High Limit Switch
Male Connector to
Remote Receiver
or Wall Switch
Superiorfireplaces.US.com
INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL
WRC (Electronic Ignition)
Installing and Activating the Remote Receiver
1. Open bottom louver and locate plug receptacle. Plug receptacle
is located either on right or left side of cabinet.
2. The WRC model receiver does not require a battery. Receiver can
be installed by first plugging short extension cord into fireplace
receptacle. Then plug receiver unit into extension cord. Finally
plug ignition module plug into receiver unit (see Figure 15).
3. Activate remote handset battery by removing insulating tab on
back of handset (see Figure 16). Battery is included pre installed
4. Once battery is activated unit is ready to use.
5. Replace bottom louver panel.
Fireplace
Receptacle
Extension Cord
Figure 15 - Installing WRC Remote Receiver
Battery Cover
12 Volt Battery
Figure 16 - Installing Battery into Back of Handset
Remote
Control
Receiver
Ignition
Module
Plug
Back of Handset
Pull to
Remove
Insulation
Tab
11
Advertisement
Table of Contents
