To Replace Heater On/Off Switch - Dimplex SF55992-AU Parts And Service Manual

If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE HEATER ON/OFF SWITCH

1. Remove the firebox trim by placing your hand on the grill section, grasping the
trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing it
upside down on the top of the unit being careful not to damage any of the wiring.
5. Locate the heater on/off switch mounted on the top panel and disconnect the
wiring clips and connections noting their original locations.
6. Depress the retainer clips on the rear of the switch and push the switch out of the
rear cover.
7. Properly orientate the new switch and connect all of the wiring clips and
connections.
8. Reassemble in the reverse order as above.
13