Adapters; Removing Adapters - IBM RS/6000 44P 170 Installation Manual

Adapters

Before performing these procedures, read "Safety Notices" on page vii. Use the
following steps when removing or installing adapters.

Removing Adapters

1. Shut down the system as described in "Stopping the System Unit" on page 22.
2. Unplug the power cable.
3. Remove the left side cover as described in "Removing the Left Side Cover" on
page 23.
4. Record the slot number and location of the adapter being removed.
Note: Adapter slots are numbered from top to bottom, one through six, on the rear
5. Label and disconnect all cables attached to the adapter being removed.
36
44P Series Model 170 Installation Guide
of the system unit. Refer to "Handling Static-Sensitive Devices" on page 21
for instructions on handling static-sensitive devices.