Installing Memory Modules - IBM RS/6000 44P 170 Installation Manual

Installing Memory Modules

Notes:
1. Memory modules must be installed in pairs and in the correct slot configuration.
(Slots J1 and J2 are a pair, and slots J9 and J10 are a pair.) Refer to the illustration
in step 6 on page 31.
2. If you are replacing one DIMM of a pair, be sure to use the same FRU part number
as the good DIMM. If this is not possible, replace the pair with a matched pair.
32
44P Series Model 170 Installation Guide
1
2
Push Locking Tabs
Out to Release Memory
Module
1