Lincoln Electric WELDANPOWER SVM 113-A Service Manual page 81

F-43
FIELD DIODE BRIDGE REMOVAL AND REPLACEMENT (continued)
PROCEDURE
1. Remove the engine spark plug wire.
2. With the 5/16" nut driver, remove the 8
sheet metal screws that hold the top cover
to the control box. Remove the top cover.
3. With the 5/16" nut driver and the 5/16"
wrench, remove the 6 screws that hold the
control panel in place.
aside as far as the leads will allow.
4. Discharge the field capacitor by connecting
the jumper wire clips on the black and the
red wire terminals on the top of the capac-
itor. See Figure F.17 for location. Leave the
clips on for at least 5 seconds, then
remove.
TROUBLESHOOTING & REPAIR
FIGURE F.17 - DISCHARGING THE FIELD CAPACITOR
Attachment for
202
202B
(-)
Cable Tie
Capacitor
Move the panel
WELDANPOWER 125
Attachment for
201C
201B
201A
(+)
Jumper
F-43