Table of Contents
Advertisement
STEP 7.
LOG #6 (SRV2005-705): Locate the notch on log #6 and place it against the front right grate tine. Set the
other end of the log so it rests on the fl at area of log #1. The orientation of log #6 in relation to the grate tine is shown
below.
3 3
5 5
2 2
Log Assembly Installed.
F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT clean glass with a razor blade.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
Remove wing nuts and glass clips around glass door.
Remove glass door from the appliance.
Replacing Glass Assembly
Replace the glass door on the appliance.
28
Notch
Notch
4 4
1 1
6 6
Notch engaged with
Notch engaged with
grate tine.
grate tine.
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. K • 9/08
3 3 2 2
5 5
2
G. Grilles and Trim
Install optional marble and brass trim surround kits as de-
sired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that
the bottom grille can be lowered and the trim door re-
moved.
H. Shutter Settings
Twilight-II-B
FLAT AREA
FLAT AREA
1
4 4
1 1
NG
LP
3/8 in.
Full Open
Advertisement
Table of Contents
