Identify And Locate Components - Lincoln Electric SP-135T Operator's Manual

A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the SP-135T Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The SP-135T power switch is to be in the
OFF ("O") position when installing work
cable and gun and when connecting power
cord to input power.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the SP-135T
from its carton and remove all packing material
around the SP-135T. Remove the following loose
items from the carton (see Figure A.1):
1. SP-135T
2. Gun and cable assembly
3. Literature and miscellaneous including:
a) This operating manual
b) 6 extra .023"-.025" (0.6 mm) contact tips
c) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. 2 LB. Sample Spool of Super Arc L-56 .025 MIG
Wire.
7. Handshield with filter plate and lens.
8. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the SP-135T gun liner
is ready to feed .023" (0.6 mm) -.035 (0.9 mm) wire.
The contact tip is sized for .023"-.025" (0.6 mm) wire
feeding.
INSTALLATION
(1)
SP-135T
FIGURE A.1
1
3
5
7
A-2
2
4
6
8