Table of Contents
Advertisement
®
MAGNUM PRO
100L
INSTALLATION
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch electrically live parts such
as output terminals or internal wiring.
•
Insulate yourself from the work and
ground.
•
Always wear dry insulating gloves.
Only qualified personnel should install, use or
service this equipment.
FIGURE 1
3
2
1
11
9
8
12
10
A-2
iDentify anD locate components
The Magnum
®
PRO 100L welding gun delivers wire and welding
current to the weld. The components of the gun are identified
below.
1. Nozzle - When flux-cored welding the KP3084-1 gasless
nozzle protects the mounting threads on the gun. When MIG
welding the KP3075-1-50F gas nozzle (shown) funnels the
shielding gas to the weld.
2. Contact tip - Provides electrical contact to the wire.
3. Gas Diffuser
4. Trigger
5. Gun Tube
6. Collar
7. Gun Handle
8. Brass Feeder Connector
9. Feeder End Connector
10. Set Screw
11. Cable
12. Gun Liner - Wire travels through the liner from the wire drive.
The KP35-40-1 liner comes installed in the gun and will run
.025"-.035" wire. An optional KP45-40-1 liner can be
installed to run .035"-.045" wire.
5
6
7
4
INSTALLATION
Advertisement
Table of Contents
