Identify And Locate Components - Lincoln Electric SP-100T Operator's Manual

A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the SP-100T Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The SP-100T power switch is to be in the
OFF ("O") position when installing work
cable and gun and when connecting power
cord to input power.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the SP-100T
from its carton and remove all packing material
around the SP-100T. Remove the following loose
items from the carton (see Figure A.1):
1. SP-100T
2. Gun and cable assembly
3. Literature and miscellaneous including:
a) This operating manual
b) 6 extra .023"-.025" (0.6 mm) contact tips
c) Hex key wrench for removal of drive roll.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. Sample spool of .025" (0.6 mm) L-56 MIG wire.
7. Handshield with filter plate and lens.
8. Instructional video.
9. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
Accessories Section of this manual.
1) As shipped from the factory, the SP-100T gun liner
is ready to feed .023" (0.6 mm) -.035 (0.9 mm) wire.
The contact tip is sized for .023"-.025" (0.6 mm) wire
feeding.
INSTALLATION
(1)
SP-100T
FIGURE A.1
1
3
5
7
A-2
2
4
6
8
9