Identify And Locate Components - Lincoln Electric SP-135 PLUS Operator's Manual

A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the SP-135 PLUS Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The SP-135 PLUS power switch is to be in
the OFF ("O") position when installing
work cable and gun and when connecting
power cord to input power.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the SP-135
PLUS from its carton and remove all packing material
around the SP-135 PLUS. Remove the following loose
items from the carton (see Figure A.1):
1. SP-135 PLUS
2. Gun and cable assembly
3. Literature and miscellaneous including:
a) This operating manual
b) A contact tip for .030" (0.8 mm) diameter wire.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. 2lb. Spool of Super Arc L-56 .025 MIG Wire.
7. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
accessories section later in this manual.
1) As shipped from the factory, the SP-135 PLUS gun
is ready to feed .023 or .025 (0.6 mm) wire.
INSTALLATION
(1)
SP-135 PLUS
FIGURE A.1
1
3
5
7
A-2
2
4
6