Charging The Battery - Razor Ground Force Drifter Fury Owner's Manual

ASSEMBLY AND SET-UP
Attaching the Flag
1
Locate the hole located on the
top right side of the battery cover.
Insert the flag.

CHARGING THE BATTERY

Your Ground Force Drifter Fury may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 12 hours.
• Recharge time: up to 12 hours, even if the light turns green.
Recommended maximum charging time is 24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended periods
of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure the Ground Force Drifter Fury's power switch
is turned OFF when unit is not in use. If the power
Charger
Note: Make sure power is turned
OFF when unit is not in use. If
the power switch is left on for
an extended period of time, the
battery may reach a stage at which
it will no longer hold a charge.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
switch is left on for an extended period of time, the
battery may reach a stage at which it will no longer hold
a charge.
• To ensure long battery life, never store the product in
freezing or below freezing temperatures! Freezing will
permanently damage the battery.
• Run time: Up to 40 minutes of continuous ride time.
Run time may vary depending on riding conditions, rider
weight, climate, and/or proper maintenance.
• Constant stopping and starting may shorten ride time.
• Average battery life for a properly maintained unit is
approximately 250 charge/discharge cycles.
LED
1
Plug the charger plug into wall
outlet. The light on the charger
should be green.
Note: If green light (LED) does not
turn on, try a different outlet.
2
Make sure the power switch is in
the OFF position. Plug the charger
into the charger port on the Ground
Force Drifter Fury. The light on
the charger should turn red during
charging. The light will turn green
again when charging is complete.
5
WARNING:
Use ONLY with the recommended
charger. Batteries are only to be
charged under adult supervision.
The charger is not a toy. Always
disconnect the charger before wiping
down and/or cleaning the Ground
Force Drifter Fury with a damp cloth.
The charger supplied with the
Ground Force Drifter Fury should be
regularly examined for damage to
the cord, plug, enclosure and other
parts. In the event of such damage,
the Ground Force Drifter Fury must
not be charged until it has been
repaired or replaced.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Note: If the charger gets warm
during regular use, this is a normal
response and is no cause for
concern. If your charger does not get
warm during use, it does not mean
that it is not working properly.
Wall outlet - Green (stand by)
Wall outlet and unit - Red (charging)
Wall outlet and unit - Green (charged)
Note: Continue charging unit even if
light turns green prior to 12 hours.
WARNING: Failure to
recharge the battery at least once a
month may result in a battery that
will no longer accept a charge.