Before You Begin - Razor Ground Force Drifter Fury Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Ground Force Drifter Fury was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 20 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 5 for charging information).
Speed Control / Thumb Throttle
Steering Wheel
Brake Lever
Charger
(Note: Charger design may
vary from one shown)
3.
Required Tool
5 mm Allen wrench
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Spark Bar Handle
1.
Brake Adjustment
(Auxiliary)
3
2.
Charger Port
On/Off Switch
Tie Rod
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR PRODUCT.
The Ground Force Drifter Fury
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame and
all other parts. Certain aftermarket
components may not be compatible
and will void the warranty.
Product ID Locations:
See locations to the left
1. Frame (underneath unit)
2. Battery Cover
3. Charger
4. Box - side of UPC (not shown)
NOTICE: The lap/shoulder
belt arrangement supplied is not
intended for use in larger, faster
vehicles and is for "play" use only.
It is not an ASTM-approved safety
belt system and is not intended
to function as an approved lap/
shoulder/seat restraining device.
WARNING:
Turn off before conducting any
maintenance procedures.
Plastic Bag Contents:
• Charger
• Tool
• Owner's Manual
• Seat Bolts (x4)
• 1 Extra Spark Cartridge