Table of Contents
Advertisement
A-2
SAFETY PRECAUTION
ELECTRIC SHOCK can kill.
• Only qualified personnel should
perform this installation.
• Turn off the input power to the
power source at the disconnect
switch or fuse box before working
on this equipment. Turn off the
input power to any other equipment
connected to the welding system at
the disconnect switch or fuse box
before working on this equipment.
• Do not touch electrically hot parts.
----------------------------------------------------------------------------------------
LOCATION
• The Power Feed™ 10M Single Wire Feeder has an
IP21 rating, suitable for indoor use.
• The Power Feed™ 10M Single Wire Feeder should
be operated in a substantially upright position.
• Do not submerge the Power Feed™ 10M Single
Wire Feeder.
• The Power Feed™ 10M Single Wire Feeder is not
suitable for stacking.
Locate the Power Feed™ 10M Single Wire Feeder
away from radio controlled machinery. The normal
operation of the Power Feed™ 10M Single Wire
Feeder may adversely affect the operation of RF con-
trolled equipment, which may result in bodily injury or
damage to the equipment.
FIGURE A.1
INSTALLATION
POWER FEED™ 10M SINGLE WIRE FEEDER
MOUNTING
Wire Drive Mounting (See Figure A.1)
The wire drive may be mounted by using the four
holes on the bottom. Because the feed plate and
gearbox are electrically "hot" when welding, make cer-
tain the parts do not contact the any structure or per-
son.
Mount the wire drive with the drive rolls in the vertical
plane to prevent dirt from collecting in the wire drive.
Angle the drive and feed plate to prevent sharp bends
in the gun and cable and incoming wire.
Control box Mounting (See Figure A.2)
Boom model Power Feed™ 10M Single Wire Feeder's
feature a control box that mounts separately from the
wire drive.
The back of the control box has four keyhole slots for
mounting. #10 screws are recommended for mount-
ing.
FIGURE A.2
A-2
Advertisement
Table of Contents
