Raymarine mn100 User Manual page 16

mn100 Digital Display
2. If you do not have a Wind Transmitter included, sail close hauled and
press the
If the mean wind direction changes then the display may
be updated by pressing and holding the
port tack, the
button while head to wind.
See Raymarine's "Using wind shifts to your advantage" sheet for further
information.
Heading Chapter
18 Heading
depending on the current compass setting. See page 25 s26 to set.
19 Heading on opposite tack
20 Speed Over the Ground
21 Course Over the Ground
14
button then tack and, once close hauled, press the
button again.
button while sailing on starboard tack or the
Current compass heading of the vessel as measured by the
Compass Transducer.
The value displayed will be affected by the calibration routine
for the compass (see page 32 section 4.4).
The heading is displayed as degrees Magnetic or True
Compass heading that the vessel will follow should it tack
through the wind, calculated by the display. Apparent Wind
Angle and Magnetic Heading must be available for this
calculation to be made.
The vessel's speed over the ground as calculated by the
GPS Antenna or a GPS receiver.
The vessel's course over the ground as calculated by the
GPS Antenna or a GPS receiver.
button while sailing on
www.raymarine.com