Scan Operation; Priority Scan; Normal Scan - Icom IC-A110 Instruction Manual

■ Scan operation

q Push [V/M] to select the Memory mode or the VFO mode,
if necessary.
• "X" appears when in the Memory mode.
w Make sure the squelch level is set to the threshold point.
• Set the squelch level (01 to 25) where the noise is just muted.
e Push [SCAN] to start the scan.
• To change the scan direction, turn [DIAL].
• "SCAN (or P SCAN)" flashes while scanning.
r Push [SCAN] again to stop the scan.
NOTE: Normal scan or Priority scan is pre-programmed
by cloning. Please ask your dealer or system operator for
details.
ï NORMAL SCAN
• Memory lock scan
Repeatedly scans memory
channels except skip (lockout)
channels.
Mch 1
Mch 2*
SKIP
Mch 3
Mch 99
250 msec.
*: Lockout ch
SCAN OPERATION
• VFO scan
Repeatedly scans all fre-
quencies over the entire
band.
Scan step is minimum chan-
nel spacing. (e.g. 25 kHz or
8.33 kHz)
ï PRIORITY SCAN
• Priority memory scan
While scanning in the
Memory mode, priority
watch checks for a sig-
nal on the selected priority
channel every 250 millisec-
onds, and skips the lockout
channel(s).
3
lowest
highest
Start
frequency frequency
Scan
Jump
250 msec.
250 msec.
Mch 1
SKIP Mch 2*
Priority
ch
Mch 3
Mch 99
*: Lockout ch
6