Safety Training Information - Icom IC-A110 Instruction Manual

Vhf air band transceiver
Hide thumbs Also See for IC-A110:
Table of Contents

Advertisement

10

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromag-
netic energy during transmit mode. This
radio is designed for and classified as "Oc-
cupational Use Only", meaning it must be
used only during the course of employment
WA RN ING
by individuals aware of the hazards, and the
ways to minimize such hazards. This radio
is NOT intended for use by the "General
Population" in an uncontrolled environ-
ment.
• For compliance with FCC and Industry Canada RF Expo-
sure Requirements, the transmitter antenna installation
shall comply with the following two conditions:
1. The transmitter antenna gain shall not exceed 0 dBi.
2. The antenna is required to be located outside of a ve-
hicle and kept at a distance of 38 centimeters or more
between the transmitting antenna of this device and any
persons during operation. For small vehicle as worst
case, the antenna shall be located on the roof top at
any place on the centre line along the vehicle in order
to achieve 38 centimeters separation distance. In order
to ensure this distance is met, the installation of the an-
tenna must be mounted at least 38 centimeters away
from the nearest edge of the vehicle in order to protect
against exposure to bystanders.
19
To ensure that your exposure to RF elec-
tromagnetic energy is within the FCC al-
lowable limits for occupational use, always
adhere to the following guidelines:
C AU TIO N
• DO NOT operate the radio without a proper antenna at-
tached, as this may damage the radio and may also cause
you to exceed FCC RF exposure limits. A proper antenna is
the antenna supplied with this radio by the manufacturer or
an antenna specifically authorized by the manufacturer for
use with this radio.
• DO NOT transmit for more than 50% of total radio use time
("50% duty cycle"). Transmitting more than 50% of the time
can cause FCC RF exposure compliance requirements to
be exceeded. The radio is transmitting when the "TX indica-
tor" appears. You can cause the radio to transmit by press-
ing the "PTT" switch.
Electromagnetic Interference/Compatibility
During transmissions, your Icom radio generates RF en-
ergy that can possibly cause interference with other devices
or systems. To avoid such interference, turn off the radio in
areas where signs are posted to do so. DO NOT operate the
transmitter in areas that are sensitive to electromagnetic ra-
diation such as hospitals, aircraft, and blasting sites.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents