Lincoln Electric POWER MIG SVM167-A Service Manual page 66

F-30
TROUBLESHOOTING AND REPAIR
WIRE DRIVE MOTOR ASSEMBLY REPLACEMENT (Continued)
PROCEDURE
1. Remove power to the machine.
2. Lift cover to gain access to the wire drive.
See Figure F.9.
3. Using a pair of pliers, disconnect the gas
hose from the bottom of the wire drive.
See Figure F.10.
4. Using a 9/16" nut driver, remove the thick
black positive lead located just above the
gas hose. See Figure F.10.
NOTE: Disconnect lead from the wire drive
motor assembly, not the machine.
FIGURE F.9. - WIRE DRIVE LOCATION
5. Using a 5/16" nutdriver, remove the three
6. Using a 5/16" nutdriver, remove the two
7. Carefully maneuver the wire drive assem-
8. Disconnect plug J4.
POWER MIG® 215
Wire Drive
mounting screws next to the wire drive
assembly. See Figure F.10.
screws on the case front assembly. See
Figure F.11.
bly out the side of the machine to gain
access to plug J4. See Wiring Diagram.
F-30