Ariston DB62 Instruction Booklet page 3

1. General
The appliance is designed for mounting at a safe level
into an open housing which must be secured to the
backing wall.
2. Oven Housing Cabinets
The oven unit housing cabinet dimensions must
comply with Fig. 4 (see Installation Diagrams).
An air gap of 50 mm minimum must be provided at
the rear of any top or bottom cupboards or shelves
Fig. 1 (see Installation Diagrams).
Ventilation must be unobstructed, ie. from adjacent
cabinetry. This can be done by either raising the
base of the cabinets using the adjusting feet (or
spacers) or alternatively by providing a slot in the
cabinet plinth to the dimensions shown overleaf.
The air gap at the rear allows the warmed air to
pass out of the inner cabinet space, but where it is
intended to fit cupboards above the oven unit to
ceiling height it is essential that the warmed air is
exhausted through the front of the cabinet Fig. 1
(see Installation Diagrams).
If an oven unit is installed adjacent to a tall cabinet,
steam escaping from the oven when the door is
opened could condense on, and perhaps stain, the
adjacent surface. To prevent permanent staining,
the adjacent surface should be made of a material
that is heat resistant and easy to clean.
Adjacent tall cabinets should not be deeper than
the oven housing cabinet.
! IMPORTANT, it is essential that the lower cupboard is
constructed in the manner illustrated (see Installation
Diagrams), ie. having side, back and roof panels so
joined as to provide no apertures which could permit
access to the oven unit when installed.
3. Final installation
Using a spirit level, check that the housing cabinet
is level from side to side and from front to back in
its installed position.
Correct any unevenness by placing wooden
packing under the bottom of the cabinet.
Make sure that the cabinet rests firmly on the
cabinet floor without rocking
Before the oven is fitted, the cabinet must be firmly
secured to the backing wall for stability.
The oven unit should now be lifted (by 2 adults)
into the cabinet and pushed fully home.
Finally the oven unit must be secured to the cabinet
by means of the four pozi wash head screws, two
through each side trim.
Remove all packing material from the grill and oven
interior.
List of Loose Items
4 x Pozi Wash Head No. 6 x 15mm screws.
GB
3